![]() The pasty state of a non-eutectic solder can be exploited in plumbing, as it allows molding of the solder during cooling, e.g. In electrical work, if the joint is disturbed while in this "pasty" state before it fully solidifies, a poor electrical connection may result use of eutectic solder reduces this problem. Non-eutectic mixtures often exist as a paste of solid particles in a melted matrix of the lower-melting phase as they approach high enough temperatures. Non-eutectic alloys can have markedly different solidus and liquidus temperatures, as they have distinct liquid and solid transitions. In specific proportions, some alloys are eutectic - that is, the alloy's melting point is the lowest possible for a mixture of those components, and coincides with the freezing point. ![]() Soldering performed using alloys with a melting point above 450 ☌ (840 ☏ 720 K) is called "hard soldering", "silver soldering", or brazing. Alloys that melt between 180 and 190 ☌ (360 and 370 ☏ 450 and 460 K) are the most commonly used. Soft solder typically has a melting point range of 90 to 450 ☌ (190 to 840 ☏ 360 to 720 K), and is commonly used in electronics, plumbing, and sheet metal work. Solder used in making electrical connections also needs to have favorable electrical characteristics. The solder should also be resistant to oxidative and corrosive effects that would degrade the joint over time. Metals or alloys suitable for use as solder should have a lower melting point than the pieces to be joined. Solder is melted in order to wet the parts of the joint, where it adheres to and connects the pieces after cooling. ![]() Solder ( UK: / ˈ s ɒ l d ə, ˈ s ə ʊ l d ə/ NA: / ˈ s ɒ d ər/) is a fusible metal alloy used to create a permanent bond between metal workpieces. Spool of solder, 1.6 mm diameter A soldered joint used to attach a wire to a through-pin of a component on the rear of a printed circuit board (not a customary application of such joints) For the family's disappearance, see Sodder children disappearance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |